FOR THE TREATMENT OF IMPACT SURFACES AND DIE CLEANING
ZIRBLAST ceramic microspheres are used with all types of sandblasting machines.
Compressed air (dry and humid):
Resistance to high impact of the ZIRBLAST ceramic microspheres significantly reduces the consumption of sandblasting material, hence the operating costs.
Thanks to this high resistance, the ceramic microspheres generate less dust in the cabin and maintain good visibility.
Thanks to their high density, the sandblasting pressure is reduced, thus obtaining the same cleaning effect.
In case of tough dirt, the pressure can be brought up to 6 bars.
The sizes suitable for compressed air sandblasting units are: B125 - B120 - B60.
Turbine
The ZIRBLAST ceramic microspheres sensibly limit the wear of the surfaces of the dies, with an average sanding cost higher than those of the conventional material used in turbines.
The essential advantage is the reduction of costs both at maintenance level (cleaning and repair) and die replacement.
The sizes suitable for turbine sandblasting units are: B30 - B40 - B60.
|
MESH |
micron |
B20 |
20/30 |
0.600-0.850 |
B30 |
30/40 |
0.425-0.600 |
B40 |
40/60 |
0.250-0.425 |
B60 |
60/120 |
0.125-0.250 |
B120 |
120/200 |
0.070-0.125 |
B125 |
120 |
0.-0.125 |
B205 |
220 |
0-63 |
Typical crystallographic analysis:
Zircon: |
68% |
Vitreous phase: |
32% |
Theoretical density: |
3,85 g/cm3 |
| Densità relativa: |
3,76 |
Relative density: |
2,3 Kg./l. |
The information in this sheet are just a reference and have no contractual value.
